How to Refill Your Ink Cartridge
Wednesday, March 31st, 2010 | Author: moneybox

Along with this kit you would be provided with the necessary tools along with a set of instructions on how to go about filling-the-empty-ink-cartridge. The best way to re-fill an ink cartridge is to buy an ink re-filling kit. This can be bought from any online store selling ink cartridges.

Here are a few simple instructions that could be followed to refill your cartridge and it’s not very complicated.

1. Draw the ink of any one colour with the help of the syringe provided in the re-fill kit. Ideally, this should be done over the sink. This is to make sure that even if some of it spills over no documents, clothes etc. gets ruined. The amount of ink each printer holds usually varies depending upon its manufacturers. For Example, in most Epson printers the black cartridge holds about 17ml of ink and the colour cartridges hold approximately 8ml. Please refer to the instructions on your refill kit to check how much ink should be injected into the cartridge.

2. A small hole needs to be made on top of the cartridge (Could be done with a ball point pen), one for each colour chamber. The hole should be at the top of the cartridge near the label. The needle should be pushed into the hole and the ink injected slowly. If the ink is not injected slowly, it could result in foaming and air bubbles could be formed. If this happens, the re-filled cartridge might not be able to print.

Caution: If this happens, hold the cartridge over a waste paper basket upside down and swing upwards and stop suddenly. This could rectify the problem. If it doesn’t then you could clean the ink heads with cleaner or try soaking the heads. This could remove any dry ink that is clogging the ink heads and allow the ink to flow freely again.

3. The re-fill holes need not be sealed, as there are already breather holes on top of the cartridge.

4. Any ink that is left over in the syringe can be returned to the bottle. The syringe needs to be cleaned with water and dried properly before using it for another colour. It might be handy to use different syringes for different colours.

5. Once the refilled cartridge is placed back in the printer, run the cleaning cycle 1 to 3 times. If there is any gap in printing, the cycle could be run a few more times till the problem is rectified.

Discount Ink Cartridges is a website that is commitment to promote ink cartridges, toner, apple laserwriter 640p toner cartridges

Category: Hardware